| BELT -
Ultimate 140 BOS-Nitrile, impregnated belt with one side brushed.
BED - 6-5/8 in. deep x 12 ga. formed steel slider bed
powder painted. Reinforced with 3/4 in. pipe which forms sockets for guard
rails. Standard 5 ft. & 10 ft. long sections bolt together with splice
plates. 48 in. and 51 in. bed widths are available in 5 ft. lengths only.
END DRIVE - Located on discharge end of conveyor, chain
guard on left hand side.
DRIVE PULLEY - 8 in. dia. with 1-3/16 in. dia. shaft
at bearings, machine crowned and fully lagged.
TAIL PULLEY - 6 in. dia. with1-3/16 in. dia. shaft at
bearings, machine crowned.
SNUB IDLER - Adjustable 2-1/8 in. dia. for tail end 2-1/2
in. dia. for drive end. Pre-lubricated ball bearings. Guards included. |
RETURN IDLER - Adjustable
1.9 in. dia. pre-lubricated ball bearings.
TAKE-UP - Take-ups at tail pulley. Provides 4 in. of
belt take-up.
BEARINGS - Sealed, pre-lubricated, self-aligning, ball
bearings on drive and tail pulleys.
SPEED REDUCTION - Sealed worm gear C-Face speed reducer.
No. 50 roller chain to drive pulley.
MOTOR - 1 HP-230/460V-3 Ph.-60 Hz. Totally Enclosed
C-Face.
BELT SPEED - Constant 65 FPM.
CAPACITY - Maximum load per linear foot of conveyor 100
lbs. NOT TO EXCEED capacity in charts.
FLOOR SUPPORTS - Now supplied as optional equipment. |
